After installing RHEL 8, I started building a Ceph Nautilus cluster with my four TerraMaster F5-422 nodes.

In further happy distro hopping (since Ansible makes this quite painless), I installed RHEL8 on my four TerraMaster F5-422.

My new 16 port 10G switch was too loud for my taste. So I fit Noctua NF-A4x20 FLX fans instead.

I received my 3 additional TerraMaster F5-422.

Time to install CentOS Stream in preparation for Ceph Luminous.

I intend to run ceph-ansible stable-4.0 on my Fedora 31 Workstation.

Since F31 comes with Ansible 2.9, but ceph-ansible 4.0 requires ansible>=2.8.8,<2.9, I simply used python -m venv ….

This is my braindump.

This blog now runs on CentOS 8

I bough a UniFi Switch 16 XG, Board Revision 13 (UniFi Software reports 13, while in the pic below I see 11, odd).

These are my notes on initial bringup.

I installed Fedora 29 on my TerraMaster F5-422 for a quick Ceph test.

Obviously if you plan to use Fedora on this hardware for anything more than a quick test, use the latest version! Or try RHEL7 or CentOS Stream on it.

This is my braindump.

I finally received my F(x)tec Pro¹.

After checking with the shipped Android that the device was not DOA and applying all updates, I reflashed it with SailfishOS

These are my notes on installing Sailfish OS 3.2.1.20 community build.

I reinstalled my TerraMaster F5-422 with CentOS Stream.

I bought a TerraMaster F5-422.

These are my notes on initial bringup.

The following post is heavily based on Fedora on the ODROID-HC2

It is is about installing CentOS Userland armv7hl on an ODROID-HC2 (from a Fedora 31 x86_64 workstation).

The aim is to get the ODROID in a state where one can ssh as root to the host.

Both initial setup over serial and installing without using a serial console are described.